Hi all,
Time to tap into the knowledge bank if I may.
I purchased an older NOS Spearco Injectronic #750 water injection unit.
It came with the installation instructions & trouble shooting paper
work. The wiring is straight forward except for the fact that they don't
explain the connection of one important wire. All the connections except
for a yellow wire from the pressure sensing valve (I think it's also
called a hobbs valve) . This unit has a control module. The pressure
sensing valve has two yellow wires, one that returns into the control
module & the other that has a spade connector but is not described any
where in the paper work. I have called Injectronic but unfortunately
they all seem to be unfamiliar with there own units claiming that it's
not produced any more , yet it's still advertised on the internet as a
new unit. Frustrated with asking several of the shops that sell the unit
I turn to the list. Any help would be appreciated.
--
Mitch Seff
75 TR6
Oceanside, N.Y.
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|