List,
At last, I'm getting close to finishing the hard tops restoration. I
have run into a slight obstacle,
I'm at the point of installing a new rear window in place, the problem
I'm having is that I believe the window is too wide (top to bottom).
When I dry fit the window into the opening without the seal it touches
the edges of the opening. I don't believe this will allow for the seal.
I'm in need of someone's window measurement. If you have an original
window that is waiting to be installed could you please measure your
window from top to bottom along the curve, and directly across. Side to
side measurements would also be nice to have as a reference.
Thanks
ronnie
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|