Went on to check my distributor endplay today. I measure .007" with no
gasket at all. Bentley says to shoot for .005". So, I guess I don't need to
shim it. I measure the compressed gasket thickness as .015". Should I put
this in to seal the distributor pedestal or will this give too much endplay?
If not, I suppose I could just put Hylomar on the mating surfaces.
Hugh Fader
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|