Message text written by "Rick Barnard"
>Jon,
> This is a miserable job, but sometimes necessary.
> First, take out the engine.
Sometimes I think this is easier than trying to do it with the engine in
place. Moral: if you have the engine out for any reason, replace the
bushings now!
> Actually, try this first: take a strong razor knife and cut the
>bushing in half accross it's diameter. Warm the halves up a little in
>hot water, and install. Mine have been fine for 4 years.
I would add: apply a drop of super glue (r) (cyanocrylic cement) to the
mating ends of the bushings just for insurance.
Dave
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|