Hey guys. . .
If one wanted to replace the bearings in a rear hub on a solid axle TR . . .
Where is it acceptable to support the hub when using a big press to push the
shaft out the middle?
Does the hub itself have to be supported? (around the flange where the wheel
studs are)
Or. . . can it be supported by the . . . uhhh . .. what do you call it?
The inner hub that is screwed to the axle tube . . .next to the shims.
The part that has the seal in it.
Any BTDT advice?
Thanks
Scott
Leesburg, VA
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|