Subject: | Re: TR 4 Cyl Engine Factory Rear Seal and Tool Survey |
---|---|
From: | Randall <randallyoung@earthlink.net> |
Date: | Wed, 21 Nov 2001 15:22:40 -0800 |
Cc: | "Triumph Team. Net" <triumphs@autox.team.net>, Friends Of Triumph <fot@autox.team.net> |
References: | <NEBBJPFDFKDLFGGIHFHKEEDOCJAA.bradlnss@lightspeed.net> |
Brad Eells wrote: > Seems to be a lot of comment out there about the Factory original aluminum > rear crankshaft oil seal and the dimensions of the tool used to center and > place the seal. This tool is referred to on Page 1.117 of the TR4 Factory > Workshop Manual. FWIW, this is the same tool and dimension that appears in Fig 33, page B-22 of the TR2/3 Factory Workshop manual. Randall /// triumphs@autox.team.net mailing list /// To unsubscribe send a plain text message to majordomo@autox.team.net /// with nothing in it but /// /// unsubscribe triumphs /// /// or try http://www.team.net/cgi-bin/majorcool |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Stainless exhaust, thanks for the input, Gbouff1 |
---|---|
Next by Date: | Hershey Hillclimb is Back, suhring |
Previous by Thread: | TR 4 Cyl Engine Factory Rear Seal and Tool Survey, Brad Eells |
Next by Thread: | Re: TR 4 Cyl Engine Factory Rear Seal and Tool Survey, Dianne Fullam |
Indexes: | [Date] [Thread] [Top] [All Lists] |