Roger,
I used shellac, the stuff that you would use to seal wood.
Bob Labuz
1958 TR3A
1974 T140V
Roger Colson wrote:
> Hello Fellow listers,
>
> I am in the process of putting my TR3 engine back together. My
> question is what jointing compound have people used with succes
> with the felt rear bearing cap seal. This is the seal where the
> Haynes manual describes installation "Soak the crankshaft rear
> main bearing cap sealing felt in liquid jointing compound and
> carefully slide the felt down the channel as shown in the photo.
> When it is in the fully down position trim the end with a sharp knife..
>
> The jointing compounds that I have seen are like paste rather than
> liquid.
>
> Thank you,
>
> Roger
>
> Roger Colson
> 57 TR3 TS21383L "Bettie"
> sassamon@mediaone.net
> http://people.ne.mediaone.net/sassamon/TS21383L
> Natick, Massachusetts USA
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|