I have a lightened flywheel in my TR6. The material was removed from the
side that faces the engine. The machine shop put it on a lathe and cut a
trench all the way around. The trench is positioned so that it doesn't come
near the center or the outer edge of the flywheel to preserve strength.
A crude before picture:
engine side
-----==-----
-----__-----
clutch side
A crude after picture:
engine side
- -==- -
-----__-----
clutch side
At 05:08 PM 5/30/2001 -0700, David Brady wrote:
>Folks,
>
>I'd like to remove a bit of weight from my flywheel. The
>competition preparation manual talks about removing
>4lbs, but it doesn't describe exactly where to remove
>the material. Can someone describe specifically where
>the material can be removed.
--
Erik Quackenbush, V.P. Operations, Midwest Filter Corporation
1-847-680-0566 fax: 1-847-680-0832 http://www.midwestfilter.com
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|