I have at least one original on my car (the 2nd appears to be something else
as well). If anyone is friends with a machinist, perhaps I could get
accurate enough measurements to fabricate one.... If some are out there
already, I'd appreciate hearing about them as well...
Phil Pattengale
54 TR2 - TS1440-LO {project #1}
56 TR3 - TS13872-L {project #2}
56 TR3 - TS11820-L {Dad's}
56 TR3 - TS9169-LO {Anyone seen this car? - Last seen in Missouri in 1964}
phil@pattengale.org
http://www.pattengale.org
> -----Original Message-----
> Here's one, I have been busy with the reconstruction of my internal
> bonnet (hood) release system on my long door TR2. With much help from
> listers, particularly Lou Metelko I have a working system, however,
> the plungers and springs on the underside of the bonnet are from
> TR4's (at least it's a Triumph), these are the correct length but
> thinner than the original. The bonnet closes but is probably not as
> well secured as it should be. Is there anyone out there who might
> have or know of the where abouts of these early plungers and springs
///
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
///
|