Message text written by "Ronnie Babbitt"
>I still have an oil leak at the brass plug. I put it back up on stands to
solve this leak. Question, Is their anything special about the gasket
material used at the plug? I've had several suggestions to double up the
gasket. I do not have time to order and receive one before a show I'm
attending this weekend. I need to make one tomorrow. I figure it will take
all night to drain.
Suggestions welcome
<
Ronnie,
I would consider sheet rubber gasket material available at most hardware
stores in the plumbing department. Sometimes available in different
thicknesses. You can cut your favorite shape with a good pair of scissors.
Dave
///
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
///
|