Bryan - After putting in 2 new clutches in three years awhile back I
finally went to a Toyota Landcruiser release bearing paired with a Sachs
pressure plate, as suggested by others on the list. They have worked
perfectly for over a year. E-mail me 'off list' if you decide to go this
route and I can dig up my suppliers. It's obviously important to get the
right part #s. While you're at it be sure to replace the bolt holding the
fork to the cross shaft, as it is prone to failure. I had the supplier of
the release bearing send me a new cross shaft which he drilled right
through and he also included a much stronger, friction fit allen headed
bolt.
Jim Sloan, Calgary, AB
///
/// triumphs@autox.team.net mailing list
///
|