triumphs
[Top] [All Lists]

Re: removing frozen wire wheels

To: "Randall Young" <randallyoung@earthlink.net>, <triumphs@autox.team.net>
Subject: Re: removing frozen wire wheels
From: "Dave Willner" <dwillner@icontech.com>
Date: Sun, 21 Jan 2001 19:41:09 -0500
References: <001001c083ec$f7f7b320$05c110ac@dwillner1> <3A6B79CB.7E8F0023@earthlink.net>
Randall,

Sounds good. I think I'm going to try a combination of the sprays, I've
tried Gumout and some of the other lubricants before with some luck, ("some"
meaning the wheel broke loose, but I was a little slow in rinsing them and
they now need to be resprayed...) and loosening the knock-offs and rocking
the car back and forth sideways. You know what happened, this fall I
replaced the pads up before a fall foliage rally and since I had the wheels
off I resprayed the calipers, and I kept going and going and going and
evevtually sprayed the hubs in a neutral silver/grey as well. I think that
the hubs may not have been given ample time to thoroughly dry and I sort of
pushed them on a little too fast. Good lesson to learn about patience....

Thanks
Dave


[This message delayed, as it needed manual intervention by the list
administrator.  mjb.]

///
///  triumphs@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>