Paul,
I have used used rubber jaw pliers successfully. These are normally used on
aircraft wire harness connectors. They are available from specialty tool
suppliers. Sears may carry them as well.
I'll be putting my plinth back together later this weekend!
Chad
'74 TR6
----- Original Message -----
From: Paul Mitchell <paul-m@mweb.co.za>
To: Triumphs <triumphs@autox.team.net>
Sent: Saturday, January 20, 2001 12:17 PM
Subject: TR6 switch plinth removal
>
> I am busy renewing the switch plinth on my TR6. I have managed to get
> the heater, choke, fan & air control knobs off, pushing in the pins and
> pulling like hell, but I wasn't expecting that to be the easy part!
> There are 2 small and 2 large bezels. I have got the 2 small ones off -
> they had a slot in each side, so I could use 2 screwdrivers together,
> but the big ones are much trickier. They only have rounded indents on
> the sloping edge. I've been out there for an hour! Any tips? Please?
>
> Paul
> 74 TR6
|