Well, here I sit rather a little red faced... probably the same place
everyone of us has been at at some point in this project.
Remember a few weeks ago I posted a note asking about a front wheel bearing
that has a "flat" spot ?
Well, home today sick (yes really) I got boared and decided to start taking
apart the front suspention. So, after each and every bolt and washer I
retried the rotor. Sure enough, after I took off the bolt holding on the
rotor backing plate and it's mate (connected by the metal tab thingy) above
the rotor turned just great !
It turned out to be that metal locking tab for the two bolts. It was
squished and twisted in such a way that it hit someting in the hub each time
round. So, replaced it and off I go !
Thanks all for you help in this.
Pat
|