Jeff
There is a definite part for lifting the engine. It attaches to
the rear most right hand head bolt and the last upper exhaust
manifold bolt. Moss carries at last look for about $13
(838-550).
However you could make your own... or some rental engine pulling
cranes supply a chain with a general purpose attachment plate
that can be bolted to the head bolt.
Brian Sanborn
'62 TR4 CT16260L so to be "O" - Groton, MA
My TR4 Restoration Web Site
http://www.net1plus.com/users/sanborn
E-Mail: sanborn@net1plus.com
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Jeff Slaton
Sent: Sunday, December 03, 2000 1:14 AM
To: triumphs@autox.team.net
Subject: TR3A "REAR" engine pull
Is there such a bird on a TR3 or TR4 engine? I have a front
engine pull but
not a rear one. I was wondering if any one would know the
factory part if
so..
Jeff Slaton
1955 TR2 Short Door (rusty)
1959 TR3A (a little rusty and the next restor project)
1974 TR6 Driven regularly, (restored, no rust)
|