yes its threaded; thanks for the respose.
It seems like a much better idea; with the piston , rather than the sliding
spline
----- Original Message -----
From: "Barry Schwartz" <bschwart@pacbell.net>
To: "Alan" <asalvato@tampabay.rr.com>
Sent: Friday, November 17, 2000 9:41 AM
Subject: Re: tr6 sliding axle shaft
> > i saw your old message on list quest. sounds similar to what u
have.
> >is on my 76 tr6. I don"t want to take it apart unless i have to. and
> >maybe it wasn't intended to be taken apart. I was hoping u might be able
> >to advise me if it needs the boot. thanks al salvatore
> *******************************
> If it has the threaded on seal then no, it doesn't need the boot. I
> suppose you could put it on for an extra measure of protection, but it
> wouldn't be necessary.
>
> Barry Schwartz (San Diego) bschwart@pacbell.net
>
> 72 PI, V6 Spitfire (daily driver)
> 70 GT6+ (when I don't drive the Spit)
> 70 Spitfire (long term project)
|