I had mine rebuilt by Apple Hydraulics a year or so ago, they leaked and
I called, they sent me a couple of black rubber "lipped washers" to
install and even included a diagram of where to up them. Now they work
fine and no leaks./ You might call them at 1-800-882-7753 and talk to
them about getting them. I still have the diagram if you want me to fax
it to you. etc. I don't have a part number but they knew exactly what I
was talking about when I called. Let me know.
Tom Fansher
DeBary,FL
61 TR3A
62 TR4
Gbouff1@aol.com wrote:
>
> I just finished my fuel lines and upon adding gas the carbs leaked from the
> bottom of the linkage set up. I installed gross jets and readadjusted the
> float level to compensate for the small difference in height from the
> originals. The rebuild kit had cork seals(can this be the problem?). I have
> tightened the large nut on the bottom to a point where the plunger just
> starts to bind, this seems to slow the leak but not stop it.. The leaking
> appears to be coming through the brass shaft on the bottom. Will the cork
> seals sweel up an seal over time?
>
> Anybody have any suggestions?
>
> Gary Bouffard
> 59 TR3A TS58399
|