| To: | Dan Carey <appleorchard@prodigy.net> |
|---|---|
| Subject: | Re: how do you remove crankshaft nut? |
| From: | Bob Labuz <yellowtr@borg.com> |
| Date: | Sun, 02 Apr 2000 09:39:20 -0400 |
| Cc: | triumphs@autox.team.net |
| Organization: | Adirondack Minerals |
| References: | <003601bf7d8a$c690cb00$16c6fdd1@default> |
Dan, If you are talking about the fan pully extension bolt, You may have to use a Impact wrench. The previous rebuilder may have used an impact wrench to tighten it thinking it was going to spin off. Good Luck, Bob Labuz 1958 TR3A 1974 T140V Dan Carey wrote: > Need to replace front oil seal..leaks..any way to get that #4% nut off? > tried wrench wd40 etc..no luckl |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: gasket glue?, Bob Labuz |
|---|---|
| Next by Date: | gasket glue?, David Massey |
| Previous by Thread: | Re: how do you remove crankshaft nut?, Gbouff1 |
| Next by Thread: | RE: how do you remove crankshaft nut?, Davies William-qswi646 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |