Jonathan,
For a few bucks you can buy the plastic tool. Go for it, or you'll be
wrestling the damn bell housing around, half an inch from full engagement,
unable to mate the pieces properly.Then you'll find out that the fork for
the throw out bearing is cracked and you'll have to do it again, and your
wife will find you nearly in tears in the garage, the fourth beer in your
hand, blood streaming from your.. oh ...sorry, don't ask. Just buy the
tool. Trust me.
Nurse ! Time for my medication !!
Chris Ball
> -----Original Message-----
> From: Crazeecooter@aol.com [SMTP:Crazeecooter@aol.com]
> Sent: Thursday, February 17, 2000 3:09 PM
> To: triumphs@autox.team.net
> Subject: TR6 Clutch Question
>
>
> Is there a way to align the clutch without the clutch alignment tool? I
> used my fingers as a guide off the face plate of the flywheel...is that
> good
> enough?
>
> Thanks in advance...
>
> Jonathan.
|