Hi Bill
I am not sure if all of these use the same od but if there was a change from
say D type to J type this would cause a difference also there are different
sizes of needle roller bearing used on the front end where they enter the
input shaft. Not much but I hope it helps some how!
Graham.
----- Original Message -----
From: <SJagGo@aol.com>
To: <triumphs@autox.team.net>
Sent: Monday, February 07, 2000 6:49 AM
Subject: Re: GT6 vs Spitfire Overdrive mainshafts
>
> Greetings:
> Does anyone know the specific differences between a Mk1-2 GT6 OD mainshaft
> (#213561) and the Mk1-3 Spit OD mainshaft (#208142), and the 71-73 OD
> mainshaft (#TKC923)?
> Would anyone want to trade for an early GT6 OD mainshaft with either one
of
> the Spitfire OD mainshafts. The spit OD mainshafts are still available
> whereas the early GT6 is not.
> Bill Brockschmidt
>
|