>However, one thing puzzles me. There's a flat washer-like thingie, steel,
>about 1.5 inch dia., which has an annular groove machined in one face of the
>washer-- on one side, that is. My question is, which side?
***********************************
Sounds like a thrust washer to me, and a good rule of thumb with parts such
as these is the groove FACES, or mates up against the rotating unit-
(provides a place for lubricating fluid (fluif)
Barry Schwartz (San Diego) bschwart@pacbell.net
72 PI, V6 Spitfire (daily driver)
70 GT6+ (when I don't drive the Spit)
70 Spitfire (long term project)
|