In a message dated 1/8/00 5:49:07 PM Eastern Standard Time,
robandmaggie@email.msn.com writes:
<< I need to install my clutch slave cylinder and flat out can't remember
>on which side of the mounting plate to install it. Do the mounting ears
>go on the front/engine side or the to the rear/transmission side?
>
>I remember a thread on the list a couple of years ago on this very
>subject. I went to the archives and searched under for solutions. I
>found two relevant messages right off the bat. Unfortunately, they offer
>opposite advice! >>
The TR3 parts manual shows the slave cyl on the tranny side, and the TR4
manual shows the opposite! Flip a coin!
FWIW I believe all of mine are done TR4 style....
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|