Ok Cosmo, You've peaked my interest. How did you do it. -Brian Sanborn
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Kramer
Sent: Saturday, December 11, 1999 2:31 PM
To: Kramer, Cosmo
Subject: Badge Bar
Hi List!
I own a TR4/A & I made my badge bar for about $15.00 two years
ago.
It's very simple. If you own a TR4 then it will cost you for just the
bar, which is even easier & cheaper. If any of you are interested then
E-mail me of the list. -Cosmo Kramer
--------------------------------------
Hi Brian & List!
You own a TR4, yes? Pick-up a bar that you want to use as you "Badge
Bar". I went to one of my machinest friends & asked what he had in
Stainless Steel. The go to your local bicyle shop & purchast two Rear
stay mounting clamps for non-braze on luggue racks. Put the clamp around
the overriders upper suport bar. Put your machine bolt through the hole
in the clamp, then the rubber cork, star washer, & nut. Put all this
inside the opening of the bar & tighten the screw. Now you are ready to
mount your badges or lights on it. If you have any question, PLEASE feel
free to ask. I own a TR4/A & had to use angles iron for mounting the bar
to it. I also milled out slots so I can rise or raze the bar as I wish.
-Cosmo Kramer
|