I know I read a thread on this before, but cannot remember. Does anybody
out there know where I can get exploded diagrams or descriptive text on
rebuilding the control head. Have any of the clubs a technical article
written on the subject. I have pulled mine apart and have the rebuild order
pretty well sussed but when pulling off the bakalite bit the chrome lever
screws to from the bakalite base a spring flew out and I cannot figure
where it came from. It is not the small one behind the brass contact, nor
is it from the "curved bar"It is a compressing spring about 3/4" long,
anyone any ideas.
John Gillis
1954 TR2 TS3618. October 1954 (ground up)
1964 Triumph 3TA 350cc (a little gem)
Trinity College
Dublin,
IRELAND.
|