Responding to my own post. After sending the referenced message I went for
another check of my block. As a result a third hole was found in the
bearing which is in fact over on oil hole. It is fed from a branch from the
middle main bearing oil gallery. My humble apologies for wasting
bandwidth. Next time I have a problem I will draft a message with the
details, but not send it until I check it out again. Thanks, Ed
Edward R. Purcell wrote:
> Listers, I need help from someone very familiar with cam bearing hole
> locations.
>
> Background: I got my block back from the machine shop and the front
> intermediate (third from rear) bearing hole is not over an oil hole. It
> seems very unlikely that the bearing is incorrect and that the machinist
> would cover up an oil hole. .
|