Listers
i'm in the process of converting my carb TR6 to PI. All is going well so
far but I have a couple of questions regarding the fuel tank conversion:
a) In the manual I note that the two inlets into the tank are on the
same side as the filler inlet i.e. on the front half of the tank. Is this
necessary i.e. canthey be on the back half towards the trunk?
b) The return from the Pressure Relief valve has a pipe going deep into
the tank. How long is it? Is it over the tank fuel outlet?
c) The drain pipe for the electric pump exits the body via a pipe
through a grommet. How far below this exit does the drain pipe terminate?
Thanks
John
|