My problem was with the grease seals and when I contacted TRF I was swnr
replacement seals and was told that sometimes they receive bad batches of
improperly manufactured seals. all the seals were replaced 6 months ago and so
far no problem with replacements.
richard white wrote:
> Several years ago I purchased new suspension parts for the front end of my
> project. About a year ago I put everything back on the bare frame. This
> past week I put the engine and trans on the frame, and I noticed that all of
> the boots on the tie rod ends and ball joints were split and disintegrating.
> Has anyone else had this problem?
> Is there a source of good replacement boots?
> Should I be worried about the quality of the ends and joints themselves?
> TIA
> Richard White
> Tr3a
|