Both actually. There are (I think without looking) three nuts and
washers that attached to the bolts in the crash pads. These bolts go
through holes in the underside of the metal facia. The "flaps"on the
sides are then glued to the under-dash, outer-side of the metal facia.
Joe
On Wed, 13 Oct 1999 13:21:30 -0700 Steve Chandler <steve@obagy.com>
writes:
>
> Hi all,
>
> How are the lower crash pads (below the dash) fitted on a TR6? Are
> they
> stuck on, or are
> there any fasteners holding them in? If they are stuck on, can
> anybody
> recommend a good
> adhesive for this purpose.
>
> TIA
>
> Steve
Joe Burlein
72 TR-6
Melbourne, FL
Real cars are designed to carry only two people, anything else is just a
bus.
|