Fellow Scions,
Just wanted to state that I still have several sets of EP O-Rings for
anyone contemplating the rebuild of their later model Pressure
Differential Warning Actuator (PDWA). The specs on these rings are:
Cross-Section (width) of 0.070" +or- 0.003" and an Inner Diameter range
from Minimum of .234", Mean of 0.239" and a Maximum of 0.244. These
O-Rings differ than those indicated in the VTR website article. I have
a later model PDWA which is a bit different as it does not have the
circlips as shown there.
The part number for these rings, which can be verified from the PSP
website is:
Series 000, Size -010.
http://www.pspglobal.com/frameset.html
Interested parties should reply off-list to which I'll reply and forward
my address. Your cost for 2 rings is my cost plus postage, $1.50.
Gary
Digest
'75 TR6
Remanufacture Completed
|