At 09:33 AM 6/10/99 -0800, you wrote:
>
>Well yesterday I replaced all those little nylon, metal and rubber bits in
the shift linkage and you know something... it all feels like new! I am
truly amazed. There is one problem though...
>I can shove it right in reverse if I'm not careful. The shifter springs
are compressed down all the way, so I can't push down to go into reverse.
What did I do? I replaced everything as it came off.
>Any ideas?
Doug
There are two springs. One small which is held in by circlip in shifter
lever. The other is larger and longer and fits over the smaller one. Then
the plastic(I think) and metal circular and curved washers and then the big
metal piece which holds verything in place. If any of these items are out
of place or worn it could be a cause for your problem. Not really a whole
lot to screw up. I assume it didn't do this before? Mine requires very
little push down effort to go into reverse but more like a gentle slap to
the left and up.
Tom Beaver
Thanks for everybody's previous help.
>
>Douglas Aiken
>
> Complicated by design.®
>
>
>
|