triumphs
[Top] [All Lists]

Getting flywheel off a TR6 resolution

To: "The List" <triumphs@autox.team.net>
Subject: Getting flywheel off a TR6 resolution
From: "Steve Nabors" <topdown@eudoramail.com>
Date: Wed, 26 May 1999 21:22:35 -0700
Organization: QUALCOMM Eudora Web-Mail (http://www.eudoramail.com:80)
 Thanks everyone with all the advice on binding the engine in some way to get 
the flywheel off.

What I wound up doing is taking a crow bar and putting one of the upper bell 
housing studs back in and jammin the crow bar between the teeth of fly wheel 
and the stud and the left rear motor hoist ring.

Get the bolts back on I did a similar method with another stud(top center most 
stud) and using the teeth and left rear motor hoist again.

Thanks again!

Steve Nabors
B'ham AL
74 TR6(daily driver .....once again)



Join 18 million Eudora users by signing up for a free Eudora Web-Mail account 
at http://www.eudoramail.com

<Prev in Thread] Current Thread [Next in Thread>
  • Getting flywheel off a TR6 resolution, Steve Nabors <=