Hello Listers,
Well I've finally started getting into the wiring of my TR3B. Actually it
hasn't been too bad (so far), but you can expect a fair number of questions
over the next week or so, especially since I'll be incorporating some
non-original accessories. Here goes the first one.
I had new floor boards and a trunk floor put in, but they don't have those
nice rubber coated little clamps that are welded in along the way to hold
down the wiring harness as it travels to the rear. Since I don't do welding
(although the cost of the above has convinced me I had better start before
doing anything like this much work to another car!), does anyone have a
suggestion for a good alternative? What kind of clamp or clip to use? What
to attach it with? The ones in the engine bay are largely intact, so I'm
mainly concerned with ones that are pretty much out of sight --- but I sure
wouldn't mind coming up with something that looked somewhat correct while
I'm at it.
THANKS!
Dave Moag
62 TR3B (a little closer each week)
77 Spitfire (hoping to pass it's smog test tomorrow)
|