Bob :
There should be a small, rubber covered connector that goes between the
bullet connectors on the harness and the bullet connectors on the wires
leading to the fixtures. They are about an inch long, and either round
(for two wires), or rectangular (for three or four wires) in cross section.
Moss (TRF, VB, etc.) should have them.
If I've read the '98 catalog right :
Moss P/N 162-000 (2 wire) in stock $0.55
Moss P/N 161-600 (4 wire) in stock $0.95
Randall
On Tuesday, March 30, 1999 5:30 PM, BennettDat@aol.com
[SMTP:BennettDat@aol.com] wrote:
>
> I am installing new headlights, taillights, sidemarkers etc. all of which
have
> come from Moss. All parts have a "bullet" type connector. My wiring
harness
> has no female connectors. Does anyone have any suggestions as to were I
might
> get them, or perhaps an alternative?
>
> Bob Antoville
|