Would a bench grinder work with a modification on the "wheel"?
> -----Original Message-----
> From: Tony Rhodes [SMTP:ARhodes@compuserve.com]
> Sent: Tuesday, March 23, 1999 1:32 PM
> To: Triumph List; Peter Z
> Subject: RE: testing OD transmission
>
>
> Message text written by INTERNET:triumphs-owner@autox.team.net
> >I'd sure like to know a way to test the OD functionality prior to
> installation. I went through the install/remove/install routine as well
> and
> could have avoided one cycle if I knew the OD would not work.
> <
>
> Rig up an electric motor to the output shaft of the transmission. Spin it
> up to
> speed. Manually actuate the OD operating lever and see what happens
> at the input shaft?
>
> OOPS, I see that Brian told you about his Trans rebiuld/test stand. I
> have
> seen
> it in operation and it looks/works great! It also looks like it would not
> be difficult
> to make since it is an only slightly modified engine stand! Just need to
> get the
> electric motor!
>
> -Tony
|