Tim wrote:
Then I did my balancing by adjusting the spring loaded screws. Does this sound
right?
>>>>You should loosen the nut/bolt on the accordion-like connection between the
two carbs and THEN balance the carbs using the slow idle speed screws (that you
refer to as the spring loaded screws). Once the carbs are balanced tighten the
connection. You can then back one of the screws out a couple of turns on one of
the carbs and use the screw on the other carb to set your idle speed. Once
you've got your idle speed where you want it after any other adjustments
(timing, dwell, fuel mixture, etc.) then you can bring tighten the slow idle
screw (on the carb where you backed the screw out) until it touches again.
>>>>Hope it helps.
Bud
71TR6 CC57365
71TR6 CC65446
|