In a message dated 98-10-26 06:31:12 EST, you write:
<< It is at this point that I seek your assistance:
If the hole in the crank shaft pulley is TDC for Number1 cylinder,how far
along the circumference of the pulley would the 10 degree position be? I
ask this with the hope that someone has had to do this calculation in the
past. Also I presume the 10 degree BTDC mark would go to the right(ie
Clockwise)of the TDC hole in the pulley.
All suggestions appreciated.
Chris Lermanis.
TR3A 1958 >>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Elementary, my dear Watson!
Measure the diameter of the pulley, multiply by pi (3.1414 I believe), and
divide by 36.
Dividing by 360 will yield 1 degree.
Shoulda paid more attention in geometry class!
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
By the way if it isn't handy to measure the diameter for you I think I could
dig up an old pulley and measure it for you - let me know.
|