On Thu, 8 Oct 1998, Eric Straub wrote:
> From: Robert M. Lang [mailto:LANG@ISIS.mit.edu]
> Robert M. Lang wrote:
> What you need is the correct Churchill tool - these are very
> hard to come
> by.
>
> You can buy a good hub puller tool from the Triumph Sport
> Six Club (TSSC) in UK. They're not cheap though (around $130 I believe). I
> bought and used one of those to pull my hubs (67 spitfire Mk2). It has four
> holes that you put over the studs & tighten down on, then you tighten a big
> bolt in the center which pushes against a supplied bushing which pushes
> against the axle. Worked great. You can find a link to the TSSC on the
> www.vtr.org <http://www.vtr.org> website. They also sell other hard to find
> parts, like owner's handbooks and parts books.
This is true. However, the original message was about pulling apart an
outer hub on a TR6 or TR250 - the bolt circle for the TSSC device does
not have the requesite 4 by 4.5 inch circle holes that you need in order
to take apart outer TR6 hubs...
> Eric.
regards,
rml
-------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent.
Consultant MIT Computer Services |
Voice: (617)253-7438 FAX: (617)258-9535 |
-------------------------------------------------------------------------------
|