To: | CarlSereda@aol.com |
---|---|
Subject: | Re: engine rebuild |
From: | John Middlesworth <jape@email.unc.edu> |
Date: | Thu, 6 Aug 1998 16:16:38 -0400 (EDT) |
Cc: | triumphs@Autox.Team.Net |
To hold the 4-cylinder wet liners in place during a rebuild, I find it easiest to buy four or five large bolts, an inch long, along with a few large flat washers. Screw these bolts with their washers into the holes for the studs. You won't need a bolt for every hole, just enough to hold each liner down on two opposing sides. A lot easier to handle and place upside down than having studs sticking up five or six inches! John Middlesworth 1966 TR4A 1960 TR3A |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | IMHO and others, Mike Thompson |
---|---|
Next by Date: | Injector Internal O-Rings, David Hill |
Previous by Thread: | engine rebuild, CarlSereda |
Next by Thread: | fuel pump test, CarlSereda |
Indexes: | [Date] [Thread] [Top] [All Lists] |