Are you using one of those "universal" clutch alignment tools? I find
these to be very sloppy and hard to get the plate centralized. I have
used the dummy input shafts made of plastic with a lot of success.
Also have you put the tranny in gear and tried turning the drive shaft
flange back and forth while pushing the tranny in - this often helps.
cheers
The Brinkers wrote:
>
> What is the secret? I have replaced my clutch and used the alignment tool.
> Now as I am refitting my Transmission, I can not get it in! I had it
> aligned correctly and cot the two mating surfaces (the bell housing and the
> engine) only 2 inches apart but I could not get them any closer. I have
> raised the motor slightly upward toward the rear to help but still no luck.
> Could someone who has been through this make some suggestions. I would very
> much appreciate it.
>
> Mike - Trying to get on the road again 74 TR6
--
Steve Chandler - Chandler-O'Bagy Associates stevec@rtd.com
|