Hello Hugh,
I don't need the piston, Jack did, but he has one now. I do, however,
need both exterior door handles for a TR4. If you have any, or know of
someone who does, I'd appreciate the info.
Regards Fisher
At 10:21 PM 5/18/98 -0400, you wrote:
>Hi Albert.
>
>You're looking for a used 83 mm piston? Would that be a standard TR4-4A
>piston?
>
>I believe I still have a complete set, pistons and liners....maybe even
>the rods also. If that is what you are looking for, let me know and
>we'll see what we can work out.
>
>Hugh R. McAleer
>Jonesboro, GA
>
>On Mon, 18 May 1998 17:17:58 -0500 Albert F Jones <fisher@hctc.net>
>writes:
>>
>>
>>Hello Jack,
>>
>> I am sure that this is not what you had in mind, but, I
>>thought I would
>>let you know about them anyway. I am still looking for a used 'G'
>>piston,
>>however, in the meantime I have found an NOS set of Mahle pistons
>>83mm.
>>std. (circa 1965). E-mail me if you are interested.
>>
>> Fisher Jones
>>
>>At 09:52 AM 5/1/98, you wrote:
>>>
>>>I am patching my currently installed TR3A engine, while I am building
>>up a
>>>new engine to install in my TR3. I had some broken compression
>>rings, no
>>>liner damage, but one piston has some hot gas erosion damage. I'm
>>going to
>>>hone and re-ring, but I have to replace the one eroded piston.
>>>
>>>I am looking for a 83mm "G" piston. It doesn't have to be perfect,
>>just
>>>serviceable.
>>>
>>>Thanks,
>>>
>>>Jack
>>>
>>>
>>
>>
>
>_____________________________________________________________________
>You don't need to buy Internet access to use free Internet e-mail.
>Get completely free e-mail from Juno at http://www.juno.com
>Or call Juno at (800) 654-JUNO [654-5866]
>
>
|