Rec'd a couple comments about TRF being backordered and that pre-60000
fit ok on pre-60000 cars.
So I am still looking for some advice.
Thanks
Carl
> -----Original Message-----
> From: Musson, Carl [SMTP:musson@satie.arts.usf.edu]
> Sent: Tuesday, April 21, 1998 9:35 AM
> To: 'Triumphs'
> Subject: TR3 Floorpan question
>
>
> I have decided the driver's floorpan is beyond redemption. M, VB, &
> TRF
> all list replacements for around $200. Post-60000 appears not to be
> available and M & TRF both say that Pre-60000 can be used with a
> little
> "coaxing" or re-working.
>
> My questions are:
>
> How much coaxing am I looking at?
> Is the VB offered one basically the same?
> Is there another source that might have the correct pan?
> Is there any difference in quality, fit, etc between the three?
> Any suggestions on the install. It appears to be straightforward,
> except for whatever amount of fitting it takes.
>
> As usual, the knowledge and guidance put forth by the list is greatly
> appreciated.
>
> Later,
> Carl F. Musson,
> You can't tell which way the car went by looking at the road...
> TR3A's - TS25264L (Driver) & TS81802LO - (Body-off in progress)
> Tampa, Florida (USA)
> http://www.arts.usf.edu/~musson/triumph/
>
>
>
|