PBR

[Malcolm Walker <walker05@camosun.bc.ca>]

On Fri, 3 Apr 1998, Barry Schwartz wrote:

> I was a little hasty in my last report on this item.  Apparently it is NOT
> a genuine Girling part but cast on the other side (hidden by the master
> cylinder) was "PBR" in a little (approx. 1/2 in X 3/4 in) rectangle with
> rounded corners.  I erroneously stated that it was a Girling part because

All my rebuild kits, save the (expensive...) one for the clutch slave,
were made by PBR.  No failures yet, I expect that's who got all the moulds
when Girling sold 'em.

-Malcolm