Ray,
OK, No more Aggie Jokes.
I replaced a single piston from British Parts Northwest. However, that
is where I bought my set originally, so I knew it was a matched piston.
If you know the manufacturer of the piston that is being replaced, or it
doesn't matter, give BPNW a call at 503-864-2001. They likely can
help. (No financial interest bla, bla, bla...)
Joe Curry
r-james@tamu.edu wrote:
>
> For a 1500 cc Spitfire engine:
>
> Well, I'm told I don't need a new block, whatta relief!
>
> I do need one piston, to replace the nearly new 0.040-over flat-
> top piston I just burned a hole in!
>
> Anybody else out there with a fraction of a set of these pistons,
> or who would like to become a partner in a set of four new
> pistons? The other three in my block are perfectly fine;
> if I can find a source for one, it would probably be cheaper. Do
> any of the usual suppliers sell Spitfire pistons by the each?
>
> Best regards,
> Ray
> -------------------------------------
> Ray W. James, P.E., Ph.D.
> Texas Transportation Institute
> Civil Engineering Department
> Texas A&M University
> College Station, TX 77843
> Phone (409)845-7436; Fax (409)845-3410
> E-mail: r-james@tamu.edu
> Date: 3/25/98 Time: 3:31:18 PM
> -------------------------------------
--
"If you can't excel with talent, triumph with effort."
-- Dave Weinbaum in National Enquirer
|