Can anyone tell me the factory head thickness dimension (not sure what
it's called) for a TR3. I have a head that I would like to use on an
engine and it has been milled. I need to know if the thickness dimension
of my head (3.330"-top edge at side to bottom edge at side- done at both
ends and middle [3.328", 3.331" and 3.329" respectively-3.330"] is the
average) is within factory specs so that I will not have any problems
after instalation with too much compression, overheating, etc.
TIA,
Lenny Seidman
--
Lenny Seidman
Elkins Park, Pennsylvania, USA
email: lseidman@erols.com
|