Ken,
This is not normal and the car will not run well (hard to tune and
exhaust pipes sooty). Replacing the jets will solve this problem. Apple
Hydraulics carries the jets and they use a Honda Valve guide to press the
new jets in and out. Give them a call and they'll sell you the jets and
the honda valve guide. If you prefer, I'm sure you can send the carb
body and they'll do this for you.
Apple Hydraulics
1-800-882-7753
No financial interest, etc., etc.... Just a satisfied customer
Terry Geiger
1974 Triumph TR6
Recovering Sunbeam Addict
Florence, Alabama USA
On Wed, 04 Feb 1998 14:39:14 -0500 Ken Mendelson <kam@tis.com> writes:
>I've been rebuilding my ZS carbs. I've noticed that the jet hole
>seems to
>be a bit oblong such that the metering needle never quite closes off
>the
>hole completely. Is this normal? If not, is there anything I can do
>about
>it? The jet seems pressed in, so changing it seems out of the
>question.
>
>Thanks.
>
>
_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]
|