use the old socket trick, one socket that has an od smaller than the
bearing cap and another socket with an id larger than the opposite
bearing cap, put the smaller one in one side and the larger one on the
other side and use either a vice (bench press for you old machineists)
or a 6 inch c-clamp to push the bearing cap out the other side. hitting
them only causes sore thumbs and frustration.
larry
>
>Since I've got the diff out, I thought I'd do the u-joints as advised
>by this list. I've got the snap rings out, but I can't figure out how
>to get the bearing caps out. I tap tap tap on the yoke with my mallet,
>but the caps don't budge. Any suggestions from the list?
>
>Thanks,
>Keith M. Taylor
>1975 TR6
>
>
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
|