>>>>> "karim" == karim marouf <karim.marouf@cancom.com> writes:
karim> Any suggestions on what might be going on? I
karim> haven't tuned the carbs yet,=20 but I imagine that
karim> if I left it this way, then that carb would rob
karim> power and=20 always run lean since the piston would
karim> rise too slowly in response to greater throttle=20
karim> openings=2E
Sounds like the damper rod is bent or off-centre a little.
Swap dampers and see if the problem moves. I had this on a
"new" rebuilt carb from one of the Big Three. A little
measurement and TLC with finger pressure got it straight again
for me. I was luck and it wasn't the piston that was bent up.
YMMV.
-MM
|