Bob Jones wrote:
> rgb@exact.com wrote:
> >
> > Does anyone have a source for Stainless Steel Brake lines
> > for the TR6? Not the hoses, but a complete set of SS lines
> > pre-bent on a CNC machine?
> >
> > This is cheaper than cleaning the old ones and replating, not
> > to mention the elimination of rust, kinks, etc. and lasting shine.
> >
> > Thanks,
> >
> > --
> > Roger G. Bolick, rgb@exact.com 512-794-9567, FAX 345-2879
>
> Roger;
> By now you have gotten plenty of information on SS brake lines including
> their high cost. An alternative I found are the cupro-nickel brake line
> sets made and sold by Automec in the UK. This material combines the
> best of both metals and the kit is complete including a special wrench
> and new pipe clips and comes in a special oil-resistant box, perfect for
> the garage floor. Every pipe is color coded and is just the right
> size. They are not pre-bent and require a special 3-16ths pipe
> bender(available from Eastwood). Unlike pure copper, once bent its best
> not to bend again more than a little bit. They are not that hard to
> install, just take one pipe off at a time and use for a template. The
> cost is a little over a $100 and they take orders by phone and accept
> Visa and MC. Phone 1280-822818. No financial interest-----
> Bob
Roger,
If you want to settle for copper, they are this months special at Spitbits -
$85 I believe. You can find them at <www.spitbits.com
Regards,
Ed Hamilton
'80 Spitfire
|