If the grease fitting is on the end of the clutch fork cross shaft,
someone at some time installed a TR3 (I think) shaft, which is the same,
except for the grease fittings. The fittings allow you to grease the
bushings in the tranny housing, so the shaft doesn't wear out.
--
http://websites.i2020.net/~webdeb/ //\
===================================(( )))===|===|===|===|===|
Cuckoo's Nest ((\ (o.__
webdeb@i2020.net (\>>> (9
cpoulin@i2020.net (<<<< \___/.~~;
65 Galaxies, TR6s (\>>>>> / ~ and critters
=============================(\<<<<< /======================
|