Jack I. Brooks wrote:
>
> Scott,
>
> I never could get the filler plug out of the TR4 tranny in my TR3. I ended
> up making a round plug out of a square one. What I did was pull off the
> tranny cover, in neutral, measure the height from the bottom of the plug to
> top of tranny housing, less the cover, measure to that height on the inside
> and fill it up.
>
> The next time the tranny is out, I will have a 3 foot bar welded to the plug
> and pull it out.
>
> Jack Brooks
>
> Jack:
I am slowly getting to the same conclussion with my plug! Not sure I
understand
your temporary fix? I'd have to remove the dash support, remove the
carpet and
under padding over the tunnel, remove the tunnel, remove the top of the
tranny
cover, and then pour in oil to plug height or possible drain (this plug
is fine)
the oil and fill up per capacity (2.9 pints I think without checking
manual)!
Scott Suhring
Elizabethtown, PA
'70 TR6
|